TCH.1C-27J-2-27JG
2-8.1
) , (refer to
figure
) and (refer to figure
) (Cont'd)
5.Disconnect from the LH quadrant (3) the cotter pins (6
and 7). Discard removed cotter pins.
6.Draw out the aileron cables (4) from the LH quadrant
(3).
7.Draw out the aileron cables (37 and 39) from the left
pulleys (36 and 38) upstream the tension adjuster.
8.Disconnect from pulleys of the tension adjuster (34)
the bolts (28 and 29), washers (20, 27, 30 and 31),
nuts (18 and 32) and cotter pins (19 and 33). Discard
removed cotter pins.
9.Disconnect from the lower support (22) the Aileron
Tension Regulator (34) by removing the bolt (21),
washers (23 and 24), nut (25) and cotter pin (26).
Discard removed cotter pin.
10.Disconnect from the upper support (17) the Aileron
Tension Regulator (34) by removing the bolt (16),
washer (15), nut (14) and cotter pin (35). Discard
removed cotter pin.
11.Remove the Aileron Tension Regulator (34).
2-8.2
) ,
) , (refer to figure
)
1.Connect at the upper support (17) the Aileron Tension
Regulator (34) by using the bolt (16), washer (15), nut
(14) and new cotter pin (35) (LCM NO. 00052).
Tighten bolt (AGE NO. 00054) to 10 thru 29 in lb.
2.Connect at the lower support (22) the Aileron Tension
Regulator (34) by using the bolt (21), washers (23 and
24), nut (25) and new cotter pin (26) (LCM NO.
00052). Tighten bolt (AGE NO. 00054) to 10 thru 29 in
lb.
(Cont'd)
27-10-05
2-48