TCH.1C-27J-2-27JG
2-10.2
) ,
) , (refer to figure
)
(Cont'd)
6.Insert the retaining clips (21, 23, 24 and 31) then,
acting on the turnbuckles (22, 25 and 32).
CAUTION
––––––––––––––––––––––––––––––––––
Do not perform the complete tension of
the cable.
––––––––––––––––––––––––––––––––––
7.Lock the turnbuckles (22, 25 and 32) and perform
cable tension.
8.Connect at the LH (RH) pulleys between ribs 23 and
24 (34) cable-lock clevis (38) by using pins (35),
washers flat (37) and new cotter pins (36) (LCM NO.
00052).
9.Connect at the aft pulley (15) cable-lock clevis (17) by
using bolts (16), washers (18), castellated nuts (19)
and new cotter pins (20) (LCM NO. 00052).
10.Connect at the LH pulley in the center wing section (2)
cable-lock clevis (7) by using bolts (8), washers (6),
castellated nuts (5) and new cotter pins (4) (LCM NO.
00052).
11.Remove a rigging pin (33) (AGE NO. 00181) from LH
and RH pulleys (34) in outer wing section between
ribs 23 and 24.
12.Remove a rigging pin (14) (AGE NO. 00181) from aft
pulley (15) in center wing section.
13.Remove a rigging pin (1) (AGE NO. 00181) from the
LH pulley (2) in center wing section.
27-10-05
2-70