TCH.1C-27J-2-27JG
2-27.1
REMOVAL. Remove the rudder actuator as
follows:
(Cont'd)
WARNING
––––––––––––––––––––––––––––––––––
NITROGEN VAPOR IS TOXIC. OPEN ALL
THE NITROGEN CHARGING VALVE
VERY SLOWLY TO PREVENT NITROGEN
VAPOR FROM COMINGIN TOUCH WITH
THE EYES. DO NOT BREATHE THE
NITROGEN VAPOR COMING OUT FROM
THE NITROGEN CHARGING VALVE. IT
COULD BE MIXED WITH HYDRAULIC
FLUID. IF YOU DO NOT OBEY THESE
SAFETY PRECAUTIONS, SEVERE
INJURY MAY OCCUR.
––––––––––––––––––––––––––––––––––
B.Unscrew the bolt that connects the bonding lead
actuator on structure, collect washer and bolt and
nut.
C.Disconnect two electrical connectors from the
actuator.
D.For the two rods use the following procedure:
1.Remove the cotter pin from the rod connection;
2.unscrew the bolt that connect the rod with actuator;
3.collect washers nut and bush (only for input lever
connection);
4.disconnect the rod. Repeat this operation for both
rods.
(Cont'd)
27-20-20
2-231