TCH.1C-27J-2-27JG
2-27.1
REMOVAL. Remove the rudder actuator as
follows:
(Cont'd)
A.Use a container or wiping cloth to collect drained
fluid.
B.Unscrew the nut and disconnect the inlet and
outlet pipe hydraulic system No. 1 and No. 2.
C.Close the pipes with plugs.
D.Close the four nipples on the actuator with plugs.
E.Move the rudder surface until end of travel in order
to shorten the actuator to the minimum length;this
operation must be performed to allow the exiting of
the actuator.
F.Remove the two cotter pin from the connection
bolts on the actuator, hold the actuator,
unscrewthe two bolts.
G.Remove the actuator from the aircraft.
H.Position the actuator on the workbench.
I.Remove the four nipples from the actuator.
J.Unscrew the bolt that fixes bonding lead on the
actuator, collect bonding lead and bolt.
K.Discard O-rings.
(Cont'd)
27-20-20
2-232