TCH.1C-27J-2-27JG
2-27.1
REMOVAL. Remove the rudder actuator as
follows:
(Cont'd)
CAUTION
––––––––––––––––––––––––––––––––––
Seal all open pipes and component holes
to prevent entrance of unwanted material.
––––––––––––––––––––––––––––––––––
2-27.2
INSTALLATION. Install the Rudder actuator as
follows:
NOTE
Lubricate all packings and O-ring with
hydraulic fluid.
A.Position the new actuator on the workbench.
B.Position the bonding lead on the actuator and
torque tighten the bolt in order to fix bonding lead
with actuator.
C.Insert a new O-rings on the four nipples.
D.Torque tighten the four nipples on the actuator.
E.Refill hydraulic oil into actuator, close the
inlet/outlet hydraulic connections with plugs.
F.Minimize the length of the Actuator.
G.Install the actuator on the aircraft.
(Cont'd)
27-20-20
2-233