TCH.1C-27J-2-27JG
2-28.1
REMOVAL. Remove the Rudder accumulator as
follows:
(Cont'd)
G.Hold the accumulator, then unscrew the screws
that lock the clamps fixing the accumulator.
H.Remove the accumulator from the aircraft.
I.Discard O-ring.
2-28.2
INSTALLATION. Install the Rudder accumulator as
follows:
NOTE
Lubricate all packings and O-ring with
hydraulic fluid.
A.Install the Rudder accumulator.
B.Hold the accumulator, then screw the screws that
lock the clamps fixing the accumulator.
C.Place new O-rings on the inlet and outlet pipe and
connect it on the accumulator torque tightenthe nut
on top of inlet and outlet pipe.
D.Place new O-rings on the sensorial pipe and
connect it on the accumulator torque tighten the
nuton top of sensorial pipe.
E.Remove from the aircraft the container with
drained fluid.
(Cont'd)
27-20-25
2-242