TCH.1C-27J-2-27JG
2-47.1
ADJUSTMENT PILOT (COPILOT) CONTROL
STICK TO FORWARD QUADRANT (refer to figure
) (Cont'd)
11.Disconnect the LH (RH) linkage rod (22) from LH (RH)
bellcrank (34) by removing bolt (27), washer (25),
bushings (26 and 28), castellated nut (24) and cotter
pin (23). Discard removed cotter pin.
12.Disconnect the LH (RH) linkage rod (22) from LH (RH)
forward quadrant (18) by removing bolt (17), washer
(19), castellated nut (20) and cotter pin (21). Discard
removed cotter pin.
13.Adjust the LH (RH) linkage rod (22) as for drawing
dimension (ref. 355 mm).
14.Connect the LH (RH) linkage rod (22)at the LH (RH)
forward quadrant (18) by using bolt (17), washer (19),
castellated nut (20) and new cotter pin (21) (LMC NO.
00052).
15.Connect the LH (RH) linkage rod (22) at the LH (RH)
bellcrank (34) by using bolt (27), washer (25),
bushings (26 and 28), castellated nut (24) and new
cotter pin (23) (LMC NO. 00052).
16.Disconnect the LH (RH) linkage rod (16) from LH (RH)
bellcrank (34) by removing bolt (33), washer (31),
bushings (32), castellated nut (30) and cotter pin (29).
Discard removed cotter pin.
17.Disconnect the LH (RH) linkage rod (16) from LH (RH)
control stick (12) by removing bolt (4), washer (13),
special washer (6), spring (5), spacer (7), castellated
nut (14) and cotter pin (15). Discard removed cotter
pin.
18.Adjust the LH (RH) linkage rod (16) as for drawing
dimension (ref. 350 mm).
(Cont'd)
27-30-15
2-398