TCH.1C-27J-2-27JG
Safety Conditions:
maintenance.
PROCEDURE:
2-48.1
REMOVAL. Remove control wheel as follows:
A.Disconnect the electrical connector (51VEA Pilot
side) (52VEA Copilot Side) located at the bottom of
the control column pilot (cockpit underfloor), if it is
necessary cut the tie wraps, extract all pins from
the connector (51VEA pilot side or 52 VEA Copilot
side the bigger one in order to complete the
harness extraction from the control conlumn).
B.On the Control Wheel, unlock the key washer, then
unscrew the center bolt, collect key washer and
bolt.
C.Acting on the Control Wheel, carefully remove it
from its seat by pulling backwards; during this
operation carefully pull the wiring harness out of
the control column until completion of extraction.
D.Position Control Wheel on workbench, then extract
and collect the retainings pins.
2-48.2
INSTALLATION. To install the control wheel
proceed as follows:
(Cont'd)
27-30-15
2-406