TCH.1C-27J-2-27JG
2-50.1
REMOVAL. Remove elevator actuator as follows:
(Cont'd)
3.remove washers, the bolt and the bushing.
A.Disconnect the actuator casing from the LH (RH)
lever as follow:
4.remove the cotter pin,
5.unscrew the nut,
6.remove washers, the bolt and the bushing.
A.Hold by hand and disconnect the actuator rod from
the structure as follow:
7.remove the cotter pin,
8.unscrew the nut,
9.collect washer, nuts and bush.
A.Remove the actuator from the aircraft.
B.Position the actuator on the workbench.
C.Remove the four nipples from the actuator and
discard the O-rings.
2-50.2
INSTALLATION. The installation procedure for
elevator actuator is the following:
(Cont'd)
27-30-25
2-421