TCH.1C-27J-2-27JG
2-52.2
INSTALLATION. Proceed as follows:
(Cont'd)
I.Close circuit breaker FLIGHT CONTROL ELEV
TRIM TAB EMER (1CT), located on the Overhead
Circuit Breakers Panel (271VE) in position F 5.
J.Disconnect the electrical connectors 8CTA and
8CTB.
K.Insert the spacers.
L.Install elevator emergency trim actuator.
M.Position the four fixing bolts, install washers and
nuts then torque tighten the bolts.
N.Reconnect the transmission chains.
O.Replace the connection locks.
P.Remove the rigging pin from central drum.
Q.Reconnect the electrical connectors to 8CTA and
8CTB.
R.Reconnect the bonding lead by install washer and
nut, then tight the bolt.
FOLLOW ON MAINTENANCE:
1.Restore hydraulic power system (refer to manual
2.Enable Cargo Ramp Function.
3.Close thermal insulation screen.
27-30-35
2-435