TCH.1C-27J-2-27JG
2-54.2
INSTALLATION (refer to figure
)
and (refer to figure
1.Position the Pitch feel Trim Unit (6) on its seat, then
insert the bolts (7), position the washers (10) and new
self locking nuts (11). Torque the bolts (AGE NO.
00054).
2.Replace LH (RH) Q-FEEL ACTUATOR (5) ( (refer to
) ).
CAUTION
––––––––––––––––––––––––––––––––––
The PITCH TRIM ACTR (DRIVE) (13) and
the PITCH TRIM ACTR (SLAVE) (12) must
be set to Rig position. If it is not possible
to position the TRIM to rigged position it
can be adjusted manually until this
position is reached.
––––––––––––––––––––––––––––––––––
3.Replace PITCH TRIM ACTUATOR DRIVE (13) (
(refer to para
) ).
4.Unlock the Elevator rear quadrants (3 and 9) and the
Control Wheel (2), remove rigging pins (1, 4 and 8)
(AGE NO. 00181) inserted.
FOLLOW ON MAINTENANCE:
1.Enable Cargo Ramp Function.
2.Connect electrical power to aircraft (refer to manual
3.Restore hydraulic power system (refer to manual
4.Close thermal insulation screen.
5.Perform the functional test:
A.MANOEUVRE EFFORT AND Q-FEEL
FUNCTIONAL CHECK (refer to para
27-30-40
2-459