TCH.1C-27J-2-27JG
2-56.1
(refer to figure
CAUTION
––––––––––––––––––––––––––––––––––
The PITCH TRIM ACTR (DRIVE) (18) and
the PITCH TRIM ACTR (SLAVE) (17) must
be set to rig position. If it is not possible
to position the TRIM to rigged position it
can be adjusted manually until this
position is reached.
––––––––––––––––––––––––––––––––––
5.Remove bolts (13 and 15), washers (12 and 14) and
self locking nuts (19 and 27) and disconnect the Pitch
trim actuator (drive) (18) from Pitch feel trim unit (7).
Discard removed self locking nut.
6.Disconnect the shaft (16) that connect the Pitch trim
actuator (drive) (18) to Pitch trim actuator (slave) (17).
2-56.2
INSTALLATION (refer to figure
)
and (refer to figure
CAUTION
––––––––––––––––––––––––––––––––––
The PITCH TRIM ACTR (DRIVE) (18) and
the PITCH TRIM ACTR (SLAVE) (17) must
be set to rig position. If it is not possible
to position the TRIM to rigged position it
can be adjusted manually until this
position is reached.
––––––––––––––––––––––––––––––––––
1.Position the Pitch trim actuator (drive) (18).
2.Fix the Pitch trim actuator (drive) (18) to the Pitch feel
trim unit (7) using bolts (13 and 15), washers (12 and
14) and new self locking nuts (19 and 27).
(Cont'd)
27-30-40
2-468