TCH.1C-27J-2-27JG
2-62.1
STALL WARNING SYSTEM TEST MODE Refer to
(refer to figure
(Cont'd)
2.Set the engine throttle levers (3) below FLT IDLE
position (< 30.4
°
).
3.Verify that the pushbuttons STICK SHAKER PILOT
(1) and COPILOT (2) (FCS control panel) are not
selected. (The "OFF" legend on pushbutton
extinguished).
4.Select STALL TEST from the GCAS and STALL page
by pressing the Line Select key Right 2.
5.Verify that the following conditions occur for the
duration of the test (approx. 5 sec.):
-the STALL TEST legend on both SAMU pages is
highlighted;
-the STALL special alert is displayed on PFD (4)
red colour and flashing;
-the STALL voice warning is audible on headset ;
-both the stick shakers are activated.
6.After approximately 5 seconds, verify that:
-the STALL TEST legend on both SAMU pages is
no longer highlighted;
-the STALL special alert disappears from PFD;
(Cont'd)
27-30-55
2-498