TCH.1C-27J-2-27JG
2-82.2
) (Cont'd)
3.With the LH spoiler closed and the actuator fully
extended, connect and adjust properly the spring rod
between the reverse control lever and mechanical
mixer so that the connecting bolts enter freely without
loading the spring.
4.Adjust and install the spring rod between the quadrant
on LH outer wing and the reverse control lever so that
the connecting bolts enrty freely without loading the
sping.
5.Remove the rigging pin (4) (AGE NO. 00181) in the
quadrant (1) of the LH outer wing and from the
reverse control lever (2) .
6.Install properly on LH control wheel the tool (AGE NO.
00066) for control wheel travel measurement and the
inclinometer (AGE NO. 00061).
7.Rotate the control wheel 4.5
˚
leftwards and maintain.
8.Adjust properly and connect the rod connecting lever
to mixer so that it can be connected freely.
9.Also remove the rigging pin (4) (AGE NO. 00181) from
the mechanical mixer (5) and return the control wheel
to neutral.
10.Increase slowly the hydraulic pressure to 3000 psi
(210 kg/cm
²
) (AGE NO. 00262).
11.Rotate slowly leftwards the control wheel and check
that the spoiler begins to move when the control
wheel angle is 4.5
˚
±
0.5
˚
.
12.Annul the hydraulic pressure.
2-82.3
ADJUSTMENT SPOILER CONTROL LINE RH
SIDE (refer to figure
1.Ensure that the left Lift Dumper actuator is
disconnected.
(Cont'd)
27-60-00
2-635