TCH.1C-27J-2-27JG
2-87.1
CHECK OF FCS1 CONTROL PANEL LIFT
DUMPER (refer to figure
12.Return the engine throttle (7) below the Flight Idle
position.
13.Move one engine throttle (7) above the Flight Idle
position and check that the LIFT DUMPER ARMED
message is illuminated again.
14.Set the LIFT DUMPER switch (4) to OFF position and
check that the LIFT DUMPER ARMED message
extinguish.
Perform the following steps for stick shaker:
15.On the FCS1 Control Panel (103VE) (1) check that in
the PILOT and COPILOT STICK SHAKERS
pushbuttons (5 and 6) the OFF legend is not
illuminated.
16.Select the GCAS and STALL page on the SAMU?s.
17.Set both the engine throttle levers (8 and 9) below
Flight Idle.
18.Select STALL TEST from GCAS and STALL page by
pressing the Line Select key right 2.
19.Verify that the aural and visual alerts are activated
and that the shaker as well is activated.
20.Release the PILOT and COPILOT STICK SHAKERS
pushbuttons (8 and 9) and check the following:
A.The OFF legend illuminates.
B.The shakers stop.
21.Restore the STALL TEST function.
27-60-05
2-669