TCH.1C-27J-2-27JG
2-90.2
INSTALLATION (refer to figure
)
and (refer to figure
2.Install union (16), retainer (11) and new preformed
packing (15).
3.Lock the control wheel (2) using the rigging pin (1)
(AGE NO. 00181)
4.Insert rigging pin (4) (AGE NO. 00181) in the
mechanical mixer (3).
5.Connect the LH lift dumper actuator end (18) to the
support (8) using bolt (9), flat washer (7), castellated
nut (5) and new cotter pin (6) (LCM NO. 00052).
Torque tighten to 30 thru 35 in lb (AGE NO. 00054).
NOTE
If the mechanical mixer and LH lift dumper
actuator terminals are not aligned perform
adjustment by opereting on the actuator
length regulator.
6.Connect the LH lift dumper actuator end (18) to the
mechanical mixer (3) using bolt (19), flat washer (20),
castellated nut (22) and new cotter pin (21) (LCM NO.
00052). Torque tighten to 30 thru 35 in lb (AGE NO.
00054).
7.Refill oil the actuator (18).
8.Remove the plug from return pipe.
9.Connect outlet pipe (10) and tighten nut.
10.Remove the plug from supply pipe.
11.Connect inlet pipe (17) and tighten nut.
12.Remove container used for collect drained fluid.
13.Remove rigging pin (4) (AGE NO. 00181) from the
mechanical mixer (3).
14.Remove rigging pin (1) from the control wheel (2).
27-60-20
2-691