TCH.1C-27J-2-27JG
2-7.3
ADJUSTMENT FUSELAGE CONTROL CABLES
TENSION (refer to figure
to figure
)
1.Ensure that the rigging pin (4) (AGE NO. 00181) is
inserted in the axle (3).
2.Insert two rigging pins (9 and 10) (AGE NO. 00181)
on the LH and RH quadrant (8 and 11) located in
centre wing section.
3.Install the cables on the Pilot and Copilot line (LH and
RH side) and stretch them, acting on the appropriate
turnbuckles (7), so that the tension regulator position
is in accordance with the diagram (refer to figure
4.Remove the three rigging pins (4, 9 and 10) (AGE NO.
00181) then re-insert the rigging pin in the quadrant.
Check that the two rigging pins (9 and 10) in the LH
and RH quadrant (8 and 11) in the centre wing section
can be inserted freely without causing any movement
of the control.
5.Ensure that the rigging pins (9 and 10) (AGE NO.
00181) are inserted in LH and RH quadrant (8 and 11)
in the center wing section.
6.Install the interconnecting cables between LH and RH
quadrant (8 and 11) and stretch them, acting on the
appropriate turnbuckles (15).
7.Remove and re-insert the rigging pins (9 and 10)
(AGE NO. 00181) in the LH and RH quadrant (8 and
11) several times checking that they enter freely
without causing any movement of the control.
2-7.4
ADJUSTMENT OUTER WING - INSTALLATION
AND CONTROL CABLES TENSION (refer to
figure
)
1.Ensure that the rigging pins (9 and 10) (AGE NO.
00181) are inserted in left and right quadrant (8 and
11) in the center wing section.
(Cont'd)
27-10-05
2-37