background image
TCH.1C-27J-2-27JG
2-7.4
ADJUSTMENT OUTER WING - INSTALLATION
AND CONTROL CABLES TENSION (refer to
figure 
2-3, sheet 4/7
) and (refer to figure 
2-3, sheet
6/7
) (Cont'd)
2.Insert two additional rigging pins (17) (AGE NO.
00181) in left and right quadrant (16) located between
ribs 23 and 24.
3.Install the control cables on the left (right) quadrant in
the center wing and on the quadrant of the left (right)
outer wing along side the left (right) wing and stretch
them, acting on the appropiate turnbuckles (15), (refer
to figure 
2-3, sheet 7/7
) .
4.Remove and re-insert the rigging pins (9, 10 and 17)
(AGE NO. 00181) in centre section and outer wing
quadrant (8, 11 and 16) several times, checking that
they enter freely without causing any movement of the
control.
5.Measure the clearance between all quadrants end
and the cable guard bolt for the whole aileron control
and check that is in the following range:
-0.039 thru 0.078 in (1 thru 2 mm) (cable diameter
5/32 '' (4mm) );
-0.039 thru 0.062 in (1 thru 1.6 mm) (cable diameter
1/8'' (3.2 mm) ).
FOLLOW ON MAINTENANCE:
None
27-10-05
2-38