TCH.1C-27J-2-29JG
2-8.1
(refer to figure
) (Cont'd)
13.Disconnect the jumper (24) by removing screw (27),
flat washers (26, 25 and 23), self locking nut (22).
Discard removed self locking nuts.
14.Disconnect the wig-o-flex (21) on the other side of the
suction pipe (EDP) (35) and remove suction pipe
(EDP) (35).
15.Disconnect the other suction pipe (ACMP) (28) from
the reservoir (2).
16.On return filter (7) disconnect the return pipe (15).
17.Disconnect pressurization pipe (4) from the reservoir
(2).
18.Disconnect the pressurization pipe (4) from the TEE
union (47) on the pressurization line and remove this
pipe.
19.Disconnect air bleeding pipe (16).
20.Cut the lock wires (39 and 9).
21.Remove the case drain and return filter bowls (40 and
8) from the two filters (32 and 7) on the reservoir (2)
and empty them.
22.On the front and rear side of the reservoir (2) loose
the bolt fastening the clamps (1 and 3) connecting the
reservoir (2) to the nacelle structure providing that the
task is performed by one person and the reservoir is
held by another person.
23.Taking care to no damage pipes and the reservoir (2)
move off the reservoir from the nacelle frame on the
rear side and remove the reservoir (2).
24.Tighten the case drain and return filter bowls (40 and
8) to the two filters (32 and 7) on the reservoir (2).
25.Undress the reservoir (2) by removing unions (5, 14,
38, 30, 34 and 43) and O-rings (6, 13, 29, 31, 33 and
10). Discard removed O-rings.
29-10-05
2-53