TCH.1C-27J-2-29JG
CAUTION
––––––––––––––––––––––––––––––––––
Do not use drained fluid from Hydraulic
System. A hydraulic fluid leak may occur.
This would cause damage to the
equipment and loss of mission
effectiveness.
––––––––––––––––––––––––––––––––––
NOTE
This procedure is valid for left fairing. For
right fairing is similar.
2-13.1
)
CAUTION
––––––––––––––––––––––––––––––––––
Install protection caps on the
disconnected electrical connectors and
hoses.
––––––––––––––––––––––––––––––––––
1.Provide two flareless tube plug (LCM NO. 00028) and
two cups (LCM NO. 00029).
2.Use a container to collect the drained fluid.
3.Disconnect electrical connector (29DEA) (13) from
Low Pressure Switch (12).
4.Disconnect ACMP1 (ACMP2) (8) delivery pipe
through quick disconnection.
5.Remove the Low Pressure Switch outlet pipe (1) (only
LH installation remove the pipe clamp) and install the
caps.
6.Remove from high pressure filter (9), bolts (10) and
washers (11).
7.Remove the high pressure filter (9) from the left fairing
(right fairing).
8.Hold the filter (9) and loosen the HP filter nut (3) and
install the plug (LCM NO. 00028) and cap (LCM NO.
00029).
(Cont'd)
29-10-10
2-85