TCH.1C-27J-2-29JG
PROCEDURE:
1.Before removing any hydraulic components it is
recommended to mark its position and the tubes
connection with sufficient data to permit correct
assembly. When disassembling a device into its
component parts, it is recommended that it is kept in
its operating position or that every part is marked with
sufficient data to permit correct reassembly.
CAUTION
––––––––––––––––––––––––––––––––––
In many cases, corrosion results from
fingerprints caused by careless handling.
Avoid handling the units when not
necessary and keep all disassembled
parts submerged in preservative oil,
Specification (LCM NO. 00088).
––––––––––––––––––––––––––––––––––
2.Cylindrical devices with one or more moving pistons
(rams, accumulators, dampers) should not be
clamped in a vice. Take particular care to assemble
valves according to the intended flow direction. This is
indicated by arrows on the valves.
WARNING
––––––––––––––––––––––––––––––––––
ALWAYS RELEASE THE HYDRAULIC
PRESSURE BEFORE REMOVING ANY
PART FROM ITS SYSTEM.
––––––––––––––––––––––––––––––––––
1-2