TOOLING
overhauled, an air bleed procedure is required.
Fittings to swaged shall not be removed from their
package until they are required for installation.
2-3.). Push lower die block assembly out of head
assembly, making sure that upper and lower halves of
die have the same P/N and the same S/N. Joint lower
die block assembly to top of power unit (refer to figure
hydraulic hose to portable hydraulic pump making
sure that the pump has a label indicating that it
delivers 10000
centre of fitting. Slide power unit into swage head
ensuring knurled area on swage head matches the
knurled area on the power unit otherwise the two
cannot be assembled. Ensure balls in lower die block
engage with a " click " and swage head is centered on
power unit. Move power unit toward centre of fitting,
until fitting stop hits end of fitting (the fitting stop is the
larger black plate on head assembly).
MARKING BAND) is covered by fitting and that part of
tube insertion mark is outside of fitting (refer to figure