TCH.1C-27J-2-27JG
2-10.1 REMOVAL (refer to figure
) , (refer to
figure
) , (refer to figure
) and (refer to figure
)
(Cont'd)
3.Insert a rigging pin (23) (AGE NO. 00181) in the LH
pulley (27) in center wing section.
4.Insert a rigging pin (49) (AGE NO. 00181) in the aft
pulley (42) in center wing section.
5.Remove the retaining clips (15, 17, 18 and 20) then
acting on the turnbuckles (16 and 19) between frames
10 and 12. After loosen completely turnbuckles (16
and 19).
6.Remove from LH sector assy (7) the cotter pin (9).
Discard removed cotter pin.
7.Remove from RH sector assy (21) the cotter pin (22).
Discard removed cotter pin.
8.Release through pulleys (10, 11, 12, 13 and 14) LH
(RH) Aileron Fuselage Cable (3 and 4).
9.Complete release through pulleys (1 and 2) of the LH
(RH) Aileron Fuselage Cable (3 and 4).
10.Remove from support (28) of the LH pulley (27) the
fairlead (26) by removing nut locking (24) and ring
locking (25).
11.Remove from support (43) of the aft pulley (42) the
fairlead (41) by removing rings retaining (35 and 40),
nuts locking (34 and 39), fairlead (36), sector (37) and
spacer (38).
12.Remove from LH pulley (27) the cable-lock clevis (32)
by removing bolts (33), washers (31), castellated nuts
(29) and cotter pins (30). Discard removed cotter pins.
13.Remove from aft pulley (42) the cable-lock clevis (47)
by removing bolts (48), washers (46), castellated nuts
(44) and cotter pins (45). Discard removed cotter pins.
(Cont'd)
27-10-05
2-62