TCH.1C-27J-2-27JG
2-21.2 INSTALLATION (refer to figure
),
(refer to figure
), (refer to figure
)
(Cont'd)
5.Install the sector assembly (56) with two bearings (30
and 57) and spacer (27) to support (44).
6.Install cable (26) on the sector assembly (56).
7.Install fair lead sector (25), locking nuts (22 and 24)
and retaining rings (21 and 23) on the support (44).
8.On center wing section, connect cables (35)
toturnbuckles (59 and 65) and install locking clips
(58and 64).
9.On the center wing section connect cables (34)
toturnbuckles (61 and 63) and install locking clips
(60and 62).
10.Connect the bungee (20) to sector assembly (19).
11.On the right side of the cargo compartment ceiling,
frame 11, connect locking clips (15 and 17)
andturnbuckles (18).
12.On right outer wing trailing edge connect the cables (7
and 12) to turnbuckles (11 and 14) and Installlocking
clips (8, 9, 10 and 13).
13.Remove rigging pin (67) (AGE NO. 00181) from left
pulley (68) in center wing section.
14.Remove rigging pin (6) (AGE NO. 00181) from right
pulley (5) in outer wing between ribs 23 and 24.
15.Remove rigging pin (3) (AGE NO. 00181) from left
quadrant (4).
16.Remove rigging pin (2) (AGE NO. 00181) from pilot
and copilot control column (1).
27-10-15
2-168