TCH.1C-27J-2-27JG
PROCEDURE:
2-24.1 ADJUSTMENT AND CONTROL CABLES
TENSION (refer to figure
) , (refer to
figure
) , (refer to figure
) and (refer to figure
1.Ensure that the forward quadrant (2) is in neutral
position and insert a rigging pin (AGE NO. 00181) (1).
2.Lock the forward tension regulator (5) by means of a
proper tool.
3.Insert a rigging pin (8) (AGE NO. 00181) on the rear
axle in order to lock the rear quadrant (9).
4.Install the control cables between the forward and rear
quadrant then stretch them, by means of the
turnbuckles (3, 4, 6, 7, 10 and 11) located at frame 9
and 41, at a load twice the expected pre-load 54 lb
(24.49 kg) (AGE NO.00113).
5.Remove the rigging pins (1 and 8) (AGE NO. 00181)
from the forward quadrant (2) and the rear axle and
perform 25 complete pedal cycles at least.
6.Set the control cable to the correct load of 27 lb (12.25
kg).
7.Check that the terminal lugs are tightened on the
turnbuckle coupling with the same number of turns.
Furthermore check that no more than 3 threads are
visible on each terminal lug.
8.Unlock the tension regulator (5) by removing the tool
previously installed.
9.Check that the control cables are stretched in
according to the diagram (refer to figure
10.Measure the clearance between the forward (2) and
rear (9) quadrants end and the cable guard bolt for the
whole rudder control and check that is in the following
range: 1 to 1.6 mm.
27-20-05
2-199