TCH.1C-27J-2-27JG
2-25.1 REMOVAL. Proceed as follows: (Cont'd)
F.Remove the plates fair leads around of the rudder
cables between rear skin and vertical fin in the
following way:
1.unscrew bolts, collect washer and plates.
A.Remove the cable lock clevis on the rear rudder
quadrant (vertical fin) in the following way:
-Unscrew the two bolts, collect washers and
nuts, and remove the cable-lock clevis.
B.Unscrew completely the turnbuckles.
C.Remove the guard pins.
D.Remove the rudder cable.
2-25.2 INSTALLATION. Proceed as follows:
A.Install the new rudder cable.
B.Position the Rudder cables on the rudder quadrant
(Cockpit Under floor), then insert the two cotter
pins in order to fix the cable with rudder quadrant.
C.By means of turnbuckles stretch the rudder cable.
D.Install the two fair leads in the following way:
-Install the fair lead, position the washers, insert
the bolts and screw the nuts (25÷28 in lb).
E.Position the rudder cable on the rear rudder
quadrant (Vertical Fin).
F.Install the cable-lock clevis in the following way:
-Install the clevis, position the washers, insert
the bolts and screw the nuts (20÷25 in lb).
G.Insert the rigging guards.
H.Remove the rigging pins insert in order to lock
quadrants.
I.Do not perform complete stretching of the cable.
27-20-05
2-208