TCH.1C-27J-2-27JG
PROCEDURE:
2-27.1 ADJUSTMENT OF PILOT PEDAL TO FORWARD
QUADRANT (refer to figure
) and
(refer to figure
1.Set the Pilot pedal in neutral position by inserting the
rigpin (1) (AGE NO. 00181).
2.Set the forward quadrant (7) in neutral position by
inserting the rigpin (6) (AGE NO. 00181).
3.Adjust the linkage rod (4) connecting lever on frame 2
to pulley and connect between Pilot pedal assy (2)
and the lever on the forward axle.
4.Check the correct engagement verifying that the
terminal lugs of the linkage rod (4) are tightened so
that no more than 3 threads are visible on each
terminal lug.
5.Remove the rigpin (1) (AGE NO. 00181) from Pilot
pedal .
6.Remove the rigpin (6) (AGE NO. 00181) from forward
quadrant (7).
2-27.2 PILOT AND COPILOT PEDALS ASSY
CONNECTION (refer to figure
1.Ensure that both pedal assy are in neutral position.
2.Adjust the linkage rod (4) at the dimension 43.3 in
(1100 mm).
3.Connect the linkage rod (4) between the two pedal
assy so that the connecting bolts (3 and 5) can be
inserted freely.
2-27.3 ADJUSTMENT OF PEDAL AND RUDDER
END-OF-TRAVEL STOPS (refer to figure
) , (refer
to figure
) and (refer to figure
1.Install the manoeuvre effort test equipment (AGE NO.
00008) on the Copilot pedal assy
(Cont'd)
27-20-15
2-224