TCH.1C-27J-2-27JG
2-35.1 REMOVAL. Remove the Rudder trim electrical
actuator as follows: (Cont'd)
7.unscrew the castellated nut and remove the flat
washer;
8.remove the bolt;
9.remove the flat washer;
10.remove the bushing.
A.Remove the Rudder trim electrical actuator.
2-35.2 INSTALLATION. Install the Rudder trim electrical
actuator as follows:
CAUTION
––––––––––––––––––––––––––––––––––
Do not move the rudder pedals or rudder
surface while performing this operation.
––––––––––––––––––––––––––––––––––
NOTE
The rudder trimelectrical actuator in neutral
position is 8.89 in (226mm) between the
connection axis.
A.Replace the Rudder trim electrical actuator.
B.Connect the two electrical connector.
C.Place the bushing, the flat washer and nut on the
connection from Rudder trim electrical actuator to
the aircraft structure, torque tighten lightly the bolt
enough to insert the cotter pin, insert thecotter pin.
D.Screw the two screw and connect the bonding lead
to Rudder trim electrical actuator.
E.Torque tighten the bolt linking the Rudder trim
electrical actuator with mechanical linkage as
follow:
1.insert the bushing and the bolt with the flat washer;
2.screw the castellated nut and torque tighten to 18 ÷
20 in lb (0.207 ÷ 0.230 mkg);
(Cont'd)
27-20-50
2-274