TCH.1C-27J-2-27JG
2-38.1 REMOVAL. Remove the Rudder travel limitator
unit as follows: (Cont'd)
2.unscrew the castellated nuts;
3.remove the bolts;
4.remove the flat washers and bush.
A.Disconnect the two rods end from RTLU.
B.Unscrew the four bolts fixing the RTLU to the
structure in the following way:
5.unscrew the bolts;
6.remove the flat washers.
A.Remove the RTLU.
2-38.2 INSTALLATION. Install the Rudder travel limitation
unit as follows:
CAUTION
––––––––––––––––––––––––––––––––––
Do not move the rudder pedals or rudder
surface while performing this operation.
––––––––––––––––––––––––––––––––––
A.Replace the RTLU in its location.
B.Torque tighten the four bolts fixing the RTLU to the
structure as follow:
1.insert the flat washers in the bolts;
2.insert the bolts in the connections;
3.torque tighten the bolts;
A.Reconnect the two bearings rod end in the RTLU
lever end connections.
B.Screw the bolts linking the two bearings rod end to
RTLU as follow:
4.insert the flat washers in the bolts;
5.insert the bush in the connection;
6.insert the bolts in the connections;
7.torque tighten to 10 ÷ 29 in lb (0.115 ÷ 0.334 mkg)
the castellated nuts;
(Cont'd)
27-20-55
2-298