TCH.1C-27J-2-27JG
2-41.1 FUNCTIONAL TEST(refer to figure
24.At left rear quadrant connect the rod (6) to the
Hydraulic Elevator Actuator (1), using the bolt (1), the
flat washer (3) and the castellated nut (4). Torque to
18-20 in-lb, then install a new cotter pin (5).
25.At right rear quadrant connect the rod (6) to the lever
(7) using the bushing (9), the bolt (8), the flat washer
(10) and the castellated nut (11). Torque to 43 – 50
in-lb, then install a new cotter pin (12).
26.At left rear quadrant connect the rod (6) to the
Hydraulic Elevator Actuator (1), using the bolt (1), the
flat washer (3) and the castellated nut (4). Torque to
18-20 in-lb, then install a new cotter pin (5).
27.Remove from the left and right quadrant the rigging
pins 0.19 in (4.915 mm) Dia.
FOLLOW ON MAINTENANCE:
None
27-30-00
2-319