TCH.1C-27J-2-27JG
NOTE
Perform steps 2, 3 and 4 to remove Pilot
tension regulator else go to step 5.
2.Open the access panels 322E and 322B.
3.Insert rig pin (AGE NO. 00181) to rear rudder
quadrant.
4.Insert the rig pins (AGE NO. 00181) (3) to control
wheel (4) LH and RH.
NOTE
Perform steps 6, and 7 to remove Pilot
tension regulator else go to step 8.
5.Remove access panel 130AD.
6.Insert the block spacer to the rudder tension regulator
(LH side) in order to maintain the spring position.
7.Insert block to the LH (RH) elevator tension regulator
(19 and 58).
8.Loosen the bolts (14 and 36) that fix the cables
guards (15 and 35) on the rudder quadrant (12).
Collect bolts (14 and 36), self-locking nuts (17 and 33)
and washers (16 and 34). Discard removed the
self-locking nuts.
9.Loosen the flanged guard pins (69 and 71) from the
lower tension regulator support (70). Collect nuts and
washers.
10.Slack the rudder cables (13 and 38) (only for the LH
side) and LH (RH) elevator cables (23 and 62) by
means of turnbuckles (1 and 2) in the upper cargo
zone near the cabin.
11.Disconnect the cables (13, 23, 38 and 62) from their
seats by removing and discarding the cotter pins (18,
20, 28, 32, 59 and 67) from the rudder quadrant (12)
(LH side only) and from the LH (RH) elevator tension
regulator quadrant (19 and 58).
(Cont'd)
27-30-05
2-344