TCH.1C-27J-2-27JG
2-45.2 INSTALLATION (refer to figure
(refer to figure
) , (refer to figure
) and (refer to figure
) (Cont'd)
19.To perform the tension value (refer to para
20.Remove the block spacer from the rudder tension
regulator.
21.Perform cables tension with a manual tension
regulator acting to the turnbuckles (1 and 2) of the LH
(RH) elevator acting alternatively to both sides of each
cable loop.
22.To perform the tension value (refer to para
23.Remove the block spacer from LH (RH) automatic
elevator tension regulator (19 and 58).
24.Remove rig pins (AGE NO. 00181) (3) from the LH
and RH control wheel (4).
25.Remove rig pin (AGE NO. 00181) to rear rudder
quadrants.
NOTE
Perform step 26 to install Pilot tension
regulator else go to step 27.
26.Remove rig pin (AGE NO. 00181) from rear rudder
quadrants.
27.Remove rig pin (AGE NO. 00181) from rudder (12) (
LH side only ) and elevator LH (RH) quadrants (19
and 58).
FOLLOW ON MAINTENANCE:
1.Connect electrical power to aircraft (refer to manual
2.Restore hydraulic power system (refer to manual
27-30-05
2-349