TCH.1C-27J-2-27JG
Safety Conditions:
Be aware of information contained in SAFETY
PRECAUTIONS (refer to para
maintenance.
PROCEDURE:
2-50.1 ADJUSTMENT PILOT (COPILOT) CONTROL
STICK TO FORWARD QUADRANT (refer to figure
)
1.Insert a 0.19 in (4.915 mm) (AGE NO. 00181)
diameter rigging pin (1) in the proper hole of the Pilot
(2) (Copilot (3)) control wheel in order to set it in
neutral position.
2.Install the clinometer (AGE NO. 00114) on the Pilot
(Copilot) control stick and perform the calibration
procedure of the clinometer (zero position).
3.Remove the rigging pin (1) (AGE NO. 00181).
4.Slowly move the Pilot (2) (Copilot (3)) control stick
forward until the inclinometer (AGE NO. 00114)
display shows 12.5°.
5.Adjust the forward stop bolt (11) against the control
stick and tighten the lock nut (10).
6.Slowly move the Pilot (2) (copilot (3)) control wheel
backward until the clinometer display shows 13.5°
7.Adjust the rear stop bolt (8) against the control wheel
and tighten the lock nut (9).
8.Set the Pilot (2) (Copilot (3)) control wheel to neutral
position.
9.Insert the diameter rigging pin (35) 0.31 in (7.95 mm)
in the LH (RH) forward quadrant (36).
10.Insert a rigging pin (1) 0.19 in (4.915 mm)(AGE NO.
00181) in the proper hole of Pilot control wheel (2).
(Cont'd)
27-30-15
2-400