TCH.1C-27J-2-27JG
(1)Disconnect electrical power and isolate
hydraulic power.
(2)Remove Pilot (Copilot ) seat in order to get
access to L (R) Aileron Cabin Cable.
(3)To gain access to L (R) Aileron Cabin cable,
open access panel 212BZ (212DZ).
(4)Place the first quadrant L (R) side in neutral
position and insert a rigging pin.
(5)Insert a rigging pin on the center of rotation
of the pilot and copilot control wheel in order
to set it to the neutral position. (refer to
).
(6)Insert a rigging pin at bottom of control
columns and rigging pin in the front of the
control columns (upper side), in order to set
to neutral position i.a.w.
(7)Remove the retaining clips from the
turnbuckles of the L/R AILERON CABIN
CABLE. (refer to figure
C.MODIFICATION
(1)Slowly unscrew completely the turnbuckles
(count and record the number of rotations).
).
(2)Connect a typical rope between the new
cables and the old ones. (refer to figure
(3)Unscrew the bolts to lift the covers from
control column to reach the interested zone.
).
(4)Position the new L(R) Aileron Cabin Cables ,
pulling out the old L(R) Aileron Cabin
Cables.
(5)Untie the rope and discard the old Cable.
(6)Connect the new L(R) Aileron Cabin Cables
using the turnbuckles taking care the cable
route.
27-30-15
2-413