TCH.1C-27J-2-27JG
Consumable Material Required:
None
Safety Conditions:
Be aware of information contained in SAFETY
PRECAUTIONS (refer to para
maintenance.
PROCEDURE:
2-60.1 REMOVAL (refer to figure
(refer to figure
1.Lock in neutral position the control wheel (2), the rear
elevator axles (4 and 10) and the Pitch Feel Trim
Units (5 and 7) by means of rigging pins (3, 6, 8 and
9) (AGE NO. 00181).
CAUTION
––––––––––––––––––––––––––––––––––
Install protection caps on the
disconnected electrical connectors.
––––––––––––––––––––––––––––––––––
2.Disconnect the two electrical connectors (10CGA and
10CGB) (20 and 21) from the Pitch trim actuator
(drive) (18).
3.Disconnect the bonding lead (28) by removing screw
(11) and washer (29).
4.Hold the Pitch trim actuator (drive) (18) and remove
bolt (26), washers (24 and 25) castellated nut (22) and
cotter pin (23). Discard removed cotter pin.
(Cont'd)
27-30-40
2-472