TCH.1C-27J-2-27JG
Safety Conditions:
1.Be aware of information contained in SAFETY
PRECAUTIONS (refer to para
maintenance.
PROCEDURE:
2-62.1 REMOVAL. Proceed as follows:
A.Disconnect the electrical connector 119VP
(120VP) from the bottom of Pilot (Copilot) control
Column.
B.Slide the harness up from the bottom of the pilot
(copilot) control column, if it is necessary cut the tie
wraps in order to carry out harness extraction.
C.Unscrew the screws on the clamps that fix Pilot
(Copilot) Stick Shaker from Pilot (Copilot) Control
Stick and release the clamps.
D.Unscrew two cable holders.
E.Remove the Pilot (Copilot) stick shaker actuator.
2-62.2 INSTALLATION. Proceed as follows:
A.Position the Pilot (Copilot) stick shaker actuator.
B.Close the two clamps and screw the screws on the
clamps that fix the stick shaker with the control
column.
C.Screw two cable holders.
D.Connect the electrical connector from bottom of the
Pilot (Copilot) Stick Shaker to the Pilot (Copilot)
control stick.
E.If previously removed, replace the tie wraps in
order to fix harness.
27-30-45
2-484