TCH.1C-27J-2-27JG
2-64.1 JOM RE-ENGAGEMENT PROCEDURE (refer to
figure
CAUTION
––––––––––––––––––––––––––––––––––
Pay attention that the tool pin axis
coincides with the roller axis.
––––––––––––––––––––––––––––––––––
4.Allow the cam concavity to coincident with roller, then,
screw the pin slowly until the mechanism is engaged.
5.Check that the two axes are stiff each other. If not,
repeat the step 4.
6.Disconnect the resetting tool (AGE N°00227).
7.Remove the rigging pin 0.31 in (7.9375 mm) (AGE
N°00181) from the right lever.
FOLLOW ON MAINTENANCE:
None
27-30-50
2-493