TCH.1C-27J-2-27JG
2-69.6 RIGHT OUTBOARD FLAP (refer to figure
1.Remove the backlash test equipments (AGE NO.
00067) from the left inboard flap and re-install them to
the right outboard flap.
2.Repeat on the right outboard flap the backlash
procedure of left outboard flap as per step 2 and 3.
Check that the backlash is not greater than 0.3 mm.
2-69.7 RIGHT INBOARD FLAP (refer to figure
)
1.Remove the backlash test equipments (AGE NO.
00067) from the right outboard flap and re-install them
to the right inboard flap.
2.Repeat on the right inboard flap the backlash
procedure of left outboard flap as per step 2 and 3.
Check that the backlash is not greater than 0.3 mm.
2-69.8 LEFT INBOARD FLAP (refer to figure
)
1.Extend the flaps moving the flap control lever (1) to 1
position.
2.Manually move the left inboard flap laterally fully
towards one side. Perform a sign on the fixed part.
3.Manually move the left inboard flap laterally towards
the opposite side. Perform a sign on the fixed part and
check, by difference between the two signs, that the
lateral backlash does not exceed 3.5 mm.
4.Reset the left inboard flap as initial condition.
2-69.9 LEFT OUTBOARD FLAP
1.Manually move the left outboard flap laterally fully
towards one side. Perform a sign on the fixed part.
2.Manually move the left outboard flap laterally towards
the opposite side. Perform a sign on the fixed part and
check, by difference between the two signs, that the
lateral backlash does not exceed 3.5 mm.
3.Reset the left outboard flap as initial condition.
27-50-00
2-518