TCH.1C-27J-2-27JG
2-73.1 REMOVAL (refer to figure
) , (refer
to figure
) and (refer to figure
6.Extract the flap cable (4) from first pulley (6).
7.Disconnect the second pulley (24) by removing bolt
(12), washers (13 and 22), castellated nut (23) and
cotter pin (21). Discard removed cotter pin.
8.Extract the flap cable (3) from second pulley (24).
9.Remove the bolt (5), washer (27), castellated nut (26)
and cotter pin (25) fixing the top of flap tension
regulator (14) to the structure. Discard removed cotter
pin.
10.Remove the bolt (11), washers (15 and 16),
castellated nut (17) and cotter pin (18) fixing the
bottom of flap tension regulator (14) to the lower
support (10). Discard removed cotter pin.
11.Remove the flap tension regulator (14).
2-73.2 INSTALLATION (refer to figure
(refer to figure
)
1.Position the flap tension regulator (14).
2.Fix the bottom of flap tension regulator (14) to the
lower support (10) using bolt (11), washers (15 and
16), castellated nut (17) and new cotter pin (18) (LCM
NO. 00041). Torque tighten to 135 thru 150 in lb (AGE
NO. 00054).
3.Fix the top of flap tension regulator (14) to the
structure using bolt (5), washer (27), castellated nut
(26) and new cotter pin (25) (LCM NO. 00052).Torque
tighten to 30 thru 35 in lb (AGE NO. 00054).
4.Insert the flap cable (4) in the first pulley seat (6).
5.Connect the first pulley (6) to the flap tension regulator
(14) using bolt (20), washers (19 and 9), castellated
nut (8) and new cotter pin (7).
(Cont'd)
27-50-15
2-564