TCH.1C-27J-2-27JG
) (Cont'd)
4.Disconnect the flap position transducer (7CA) (6) from
the flap transducer shaft (2).
5.Remove the flap position transducer (7CA) (6).
6.Remove the flap transducer shaft (2) from the flap
jackscrew (1).
)
CAUTION
––––––––––––––––––––––––––––––––––
To prevent misalignment of control
surfaces, do not move the screwjacks
during this maintenance task.
––––––––––––––––––––––––––––––––––
NOTE
Before installation, lubricate all mechanical
elements with oil.
NOTE
Lubricate with grease (LCM NO. 00433 or
LCM NO. 00434) before installing
components jackscrews.
1.Position the flap position transducer (7CA) (6) in the
LH (RH) outboard wing.
2.Connect the other end of the flap transducer shaft (2)
to the flap jackscrew (1).
3.Connect the flap position transducer (7CA) (6) to its
support (13) using bolts (3, 14 and 15), flat washers
(7, 10 and 12) and new self locking nuts (8, 9 and 11)
(LMC NO. 00011). Torque tighten (AGE NO. 00054)
to 25 thru 28 in lb.
4.Move the flap transducer shaft (2) toward the flap
jackscrew (1) and then toward the flap position
transducer checking the groove in the opposite side is
engaged for at least 14 mm in the related connection.
(Cont'd)
27-50-40
2-597