TCH.1C-27J-2-27JG
Consumable Material Required:
None
Safety Conditions:
Be aware of information contained in SAFETY
PRECAUTIONS (refer to para
maintenance.
PROCEDURE:
2-89.1 ADJUSTMENT SPOILER CONTROL LINE LH
SIDE (refer to figure
)
1.Supply No 1 and No 2 hydraulic systems at 1000 psi,
(70.310 kg/cm²).
2.With the stem of LH spoiler servoactuator fully
extended, adjust, if necessary, rod between
servoactuator and lever so that there is a distance of
7.874 in (200) between the two connecting axes.
3.If necessary, adjust spoiler control rod (3) so that left
spoiler is aligned with outer wing trailing edge and at
0° +/- 15'.
4.Repeat operations described in steps 2 and 3 on RH
spoiler. Results must be the same.
5.Release hydraulic pressure in No 1 and No 2
systems.
2-89.2 ADJUSTMENT OF SPILER NEUTRAL
1.Ensure that the left Lift Dumper actuator is
disconnected.
2.Insert one rigging pin Dia 0.193 in (4.915 mm) (4)
(AGE NO. 00181) into the quadrant (1) of the LH outer
wing, into the reverse control lever (2) and into the
mechanical mixer (5) .
(Cont'd)
27-60-00
2-643