TCH.1C-27J-2-27JG
2-89.3 ADJUSTMENT SPOILER CONTROL LINE RH
SIDE (refer to figure
) (Cont'd)
2.Insert one rigging pin Dia 0.193 in (4.915 mm) (4)
(AGE NO. 00181) into the quadrant (1) of the RH
outer wing, into the reverse control lever (2) and into
the mechanical mixer (5).
3.With the LH spoiler closed and the actuator fully
extended, connect and adjust properly the spring rod
between the reverse control lever and mechanical
mixer so that the connecting bolts enter freely without
loading the spring.
4.Adjust and install the spring rod between the quadrant
on LH outer wing and the reverse control lever so that
the connecting bolts enrty freely without loading the
sping.
5.Remove the rigging pin (4) (AGE NO. 00181) in the
quadrant (1) of the LH outer wing and from the
reverse control lever (2).
6.Install properly on RH control wheel the tool (AGE
NO. 00066) for control wheel travel measurement and
the inclinometer (AGE NO. 00061).
7.Rotate the control wheel 4.5
°
rightwards and
maintain.
8.Adjust properly and connect the rod connecting lever
to mixer so that it can be connected freely.
9.Also remove the rigging pin (4) (AGE NO. 00181) from
the mechanical mixer (5) and return the control wheel
to neutral.
10.Use the hydraulic test stand (AGE NO. 00262), supply
slowly the hydraulic pressure to 3000 psi (210
kg/cm²).
11.Rotate slowly rightwards the control wheel and check
that the spoiler begins to move when the control
wheel angle is 4.5° ± 0.5°.
12.Annul the hydraulic pressure.
27-60-00
2-645