TCH.1C-27J-2-27JG
PROCEDURE:
2-8.1
ADJUSTMENT CABIN CONTROL CABLES
TENSION (refer to figure
to figure
)
1.Insert a 0.193 in (4.915 mm) diameter rigging pin (1)
(AGE NO. 00181) in the pilot and copilot control wheel
(2) in order to set to neutral position.
2.Open the access panels 130B and 130C (LH and RH
side) and place the first quadrant (LH and RH side) (3
and 6) in neutral position inserting a rigging pin 0.193
in (4.915 mm) (4 and 5) (AGE NO. 00181) in the
pulley.
3.Install the cables from the Pilot and Copilot control
wheel (2) to the related first quadrant (3 and 6), then
stretch them, by means of the turnbuckles (7) located
) .
NOTE
When the cables stretching is complete,
check that the terminal lugs are tightened on
the turnbuckle coupling with the same
number of turns. Furthermore check that not
more than 3 threads are visible on each
terminal lug.
NOTE
The cables, as reported in figure, have two
different sections around the turnbuckles
(1.8'' and 5/32'') (3.2 and 4 mm). The tension
value considers the smallest section.
4.Remove the rigging pins (1 and 4) (AGE NO. 00181)
from both control wheels (2) and from LH first
quadrant (3). Reinsert the rigging pin (4) (AGE NO.
00181) in the LH first quadrant (3) and check that the
rigging pins (4) can be inserted freely on the both
control wheels (2) without causing any movement of
the control.
(Cont'd)
27-10-05
2-39