TCH.1C-27J-2-27JG
2-8.2
ADJUSTMENT AUTOPILOT CONTROL CABLES
TENSION (refer to figure
to figure
) (Cont'd)
2.Insert the rigging pin (AGE NO. 00181) (13) in the
drum autopilot actuator (14).
3.Install the autopilot cable (12) between the right aft
quadrant (8) and the autopilot actuator quadrant (14),
then stretch it by means of the turnbuckles (15).(refer
)
NOTE
When the cables stretching is complete,
check that the terminal lugs are tightened on
the turnbuckle coupling with the same
number of turns. Furthermore check that not
more than 3 threads are visible on each
terminal lug.
4.Remove the two rigging pins (9 and 13) from the right
aft quadrant (8) (central wing section) and drum
autopilot actuator (14). Reinsert the rigging pin (9 and
13) in the right aft quadrant (central wing section) and
the drum autopilot actuator (14) and check that the
rigging pins (9 and 13) can be inserted freely without
causing any movement of the control.
NOTE
If the above requirement is not obtained,
re-adjust the cable tension properly.
5.Verify that the clearance between all quadrants and
the cable guard bolt for the whole aileron control is in
the range 0.039 to 0.062 in (1 to 1.6 mm) cable Dia
0.125 in (3.2 mm).
2-8.3
ADJUSTMENT FUSELAGE CONTROL CABLES
TENSION (refer to figure
to figure
)
(Cont'd)
27-10-05
2-41