TCH.1C-27J-2-29JG
2-5.3
HYDRAULIC SYSTEM 2 RE-OILING (Cont'd)
2.Move the flaps control lever to FULL to allow the flaps
to extend fully, then select UP to allow the flaps to
retract fully.
3.Repeat Flaps actuation 3 times until the Flaps circuit
is scavenged.
4.Stop the re-oiling of the Flaps circuit.
-WHEEL BRAKES NORMAL CIRCUIT
1.Connect a transparent pipe to the bleeder valve of the
four brakes and put-in in a suitable container.
2.Press fully and maintain the left brake pedal (pilot or
copilot) and maintain opened the fuse by-pass of the
LH Fwd wheel.
3.Open the bleed valve of the LH Fwd brake and allow
the oil to flow until it is of the new type (if olf fluid and
the new one are not clearly distinguishable let flow at
least 1 liter of hydraulic fluid) and free of air bubbles.
4.Close the bleeding valve and release the fuse by-pass
lever of the LH Fwd wheel.
5.Repeat steps 2. to 4. for the LH Rear wheel.
6.Press fully and maintain the right brake pedal (pilot or
copilot) and maintain opened the fuse by-pass of the
RH Fwd wheel.
7.Open the bleed valve of the RH Fwd brake and allow
the oil to flow until it is of the new type (if olf fluid and
the new one are not clearly distinguishable let flow at
least 1 liter of hydraulic fluid) and free of air bubbles.
8.Close the bleeding valve and release the fuse by-pass
lever of the RH Fwd wheel.
9.Repeat steps 6. to 8. for the RH Rear wheel.
-WHEEL BRAKES STATIC LINES
1.Remove the cap of the brake reservoir and connect
the cap adapter with transparent pipe.
(Cont'd)
29-10-00
2-32