TCH.1C-27J-2-29JG
2-5.4
HYDRAULIC SYSTEM 1 RE-OILING (Cont'd)
4.Open the bleed valve of the LH Fwd brake and allow
the oil to flow until it is of the new type (if olf fluid and
the new one are not clearly distinguishable let flow at
least 1 liter of hydraulic fluid) and free of air bubbles.
5.Close the bleeding valve and release the two fuse
by-pass control levers.
6.Repeat steps 3. to 4. on the LH Rear wheel
7.Lower and maintain the control lever of the rear
wheels fuse by-pass and the control lever of the fuse
by-pass connected to the RH fwd wheel.
8.Open the bleed valve of the RH Fwd brake and allow
the oil to flow until it is of the new type (if olf fluid and
the new one are not clearly distinguishable let flow at
least 1 liter of hydraulic fluid) and free of air bubbles.
9.Close the bleedind valve and release the two fuse
by-pass control levers.
10.Repeat steps 7. to 9. on the RH Rear wheel.
-ENGINE DRIVEN PUMP 1 CIRCUIT
1.Disconnect the pressure hose of the engine driven
pump 1.
2.Discharge the oil contained in the pipes in a separate
container.
3.Reconnect the pressure hose previously
disconnected.
-ACMP 1 CIRCUIT
1.Disconnect the pressure hose of the ACMP 1 at the
quick disconnection.
2.Discharge the oil contained in the pipes in a separate
container.
3.Reconnect the pressure hose previously
disconnected.
-NOSE WHEEL STEERING CIRCUIT
(Cont'd)
29-10-00
2-35